Kenaf decorticator is carried out at both ends:Break the tip of fresh flax bar by the feed hopper, pull the flax out from the hopper when feeding into the part at the base (close to the root) about 15cm in hand, and then turn the tip to strip the flax base. Feeding break and pulling the hemp out of the hopper are as follows
- खिलाते समय ताजा भांग का तना उपयुक्त होना चाहिए। हाथों में ताजे सन के तने की संख्या को उचित ढंग से समझने में सक्षम हों।
- खिलाते समय, भांग के डंठल को हाथों पर अगल-बगल फैलाएं और ओवरलैप न करें।
- the feeding speed should make the Kenaf decorticator break the flax bone of the stalk and the flax skin.
- धीमी गति से बाहर खींचना. बाहर खींचने की गति धीमी है और जितना संभव हो सके उतनी सुसंगत होनी चाहिए, गति के अंत को थोड़ा धीमा कर दें।
Structure of Kenaf decorticator
According to the mechanical characteristics of ramie crop stalks,On the basis of the domestic and foreign research experience of Kenaf decorticator,By adopting the design scheme of transverse-feed mode, and the ramie stalks are fed continuously and uniformly transversely through the clamping device, the non-stop processing of ramie can be realized, which can greatly reduce the auxiliary working time and improve the efficiency of flax stripping.