1. 화면의 수리 및 교체. 화면은 시트 강판 또는 철판으로 천공되어 있습니다. 화면이 마모되거나 이물질에 의해 파손된 경우, 손상 범위가 크지 않으면 리벳 또는 납땜으로 수리할 수 있으며, 면적이 손상되었으면 새 화면으로 교체해야 합니다. 화면을 설치할 때는 화면의 거친 면이 내부를 향하고 광택 면이 바깥으로 향하도록 하며, 화면과 화면 프레임이 단 tightly 부착되어야 합니다. 링 스크린을 설치할 때는 랩 결합부가 회전 방향으로 가도록 하여 재료가 랩 결합부에서 걸리지 않도록 합니다.
Second, the lubrication and replacement of the bearings. The 옥수수 분쇄기 is cleaned after every 300 hours of operation. If the bearing is oil lubricated, it is advisable to fill the bearing housing clearance by 1/3 when adding new oil, and the maximum is not more than 1/2. Just tighten the capped oil cup cover a little before operation. When the 옥수수 분쇄기 bearing is seriously worn or damaged, it should be replaced in time, and pay attention to strengthen lubrication; if using tapered roller bearing, pay attention to check the axial spacing of the bearing to keep it 0.2-0.4 mm. If there is discomfort, increase it. Reduce the paper pad at the bearing cover to adjust.
Third, the replacement of the claws and hammers. Among the pulverizing parts, the pulverizing claws and the hammer pieces are the wearing parts in the 옥수수 분쇄기, and are also the main components affecting the pulverizing quality and productivity. The pulverizing claws and the hammer pieces should be replaced in time after being worn. When the jaw crusher replaces the claws, the disc should be pulled out first. Before pulling out, first open the round nut lock piece on the back of the disc, use a hook wrench to unscrew the round nut, and then pull the disc out with a special puller. In order to ensure the balance of the rotor operation, it is necessary to pay attention to the complete set of replacement when changing the teeth. After the replacement, static balance test should be done to make the 옥수수 분쇄기 work stable. Be sure to tighten the nut when assembling the jaws, and be careful not to miss the spring washer. The qualified parts should be selected when changing the teeth. The weight difference of the single teeth should be no more than 1.0-1.5 grams.