Saba, umbizo la mashine ya kupandia halina nafasi sawa
Katika mchakato wa kupandia mchele halisi, ikiwa miche haiko sawa na umbali kati ya safu za miche si sawa, linaweza kuhusiana na mambo matano yafuatayo:
Kwanza, kunaweza kuwa na kutokubaliana kwa unyevu wa udongo wa kitanda cha miche;
Pili, kunaweza kuwa na tofauti kubwa katika shinikizo la usafirishaji wa wima;
Tatu, inaweza kuwa tofauti katika marekebisho ya sindano;
Nne, inaweza kuwa cam ya kusukuma na kuvuta, shina la upinde, upinde na kama hizo za kila mkono wa kupandia. Kiwango cha kuvaa ni tofauti;
Tano ni kwamba masanduku ya minyororo hayako kwenye kiwango sawa.
For these faults, while using the corresponding exclusion measures to eliminate, it is also possible to adjust the partial twisting machine one by one, and keep the vertical feeding stroke between 11 and 12 mm; Strict calibration is performed to keep it at the same level; if the fault cannot be eliminated, the worn device must be replaced.
Nane, the Mashine ya kupandikiza Kushinikiza si sawa
Katika mchakato wa kupandia mchele halisi, ikiwa kuna tatizo la kushindwa kwa pusher kuwa si sawa, linaweza kuhusiana na mambo yafuatayo:
Kwanza, inaweza kuwa sleeve ya mwongozo, pusher, upinde, kidole cha kutenganisha na cam. Kuvaa ni kubwa sana;
pili, inaweza kuwa spring ya kusukuma imevunjika;
Tatu, bolt inaweza kuwa imeshuka;
Nne, shinikizo la shimo la shinikizo la shaba linaweza kuwa kali sana;
Tano, inaweza kuwa shina la chini la mnyororo wa kuunganisha na shina la chini la shina la kuzunguka limeharibiwa vibaya na Rub.
Hatua kuu ni: kubadilisha shina la kuzunguka na shina la mnyororo wa kuunganisha, kurekebisha tena kiasi cha kuchukua na kukaza bolt ya kurekebisha, au kubadilisha sehemu zilizovaa.
Tisa, the Mashine ya kupandikiza‘s Kina cha marekebisho hakina udhibiti
In the actual rice transplanting machine, if there is a phenomenon of failure of the transplanting depth adjustment, it may be related to the serious wear of the fixed pin hole, the broken pin seat, and the lifting nut of the rice Mashine ya kupandikiza or the slider of the lifting rod. For these faults, the pinning seat should be welded in time, or the pin, lifting nut, lifting rod, etc. should be replaced.